![]() ![]() Sorry I don't have the original codes that led the shop to diagnose this as faulty TCM. They have to put he Original in every time to start it and shift it out of park to get it off the rack. Get codes, get data stream.Īnyone have any ideas? I've tried As built first then PMI, different routes to try to program it with IDS and nothing has worked. will not run any adaptations, I can communicate with TCM. Hard codes are TCM shift fork A and IPC no communication with TCM U code. multiple U codes from programming attempt. Shows PCM is updated, closes with TCM not programmed.Ĭheck and clear all codes. Dash goes dead, hazards on until i punch through ok on IDS asking for key on. Pulled it out and part numbers didn't match which TCM it should be. No Ford Parts were available, so Chinese TCM from Amazon. Errors out.Īfter grilling shop, vehicle is a lemon law return so even if this is a warranty covered issue, it's not covered from ford. Trans will do no relearns on any adapts or clutches. The IDS application will perform the identical functions of the WDS and. The IDS package replaces the Worldwide Diagnostic System (WDS). will not start, ICP shows no communication with TCM code. The Ford Integrated Diagnostic System (IDS) will be the only equipment that provides complete diagnostic coverage of current and future Ford, Lincoln and Mercury vehicles in North America. I can pull codes (zero) but will not shift out of park. I can communicate with the TCM, I have data stream. Dash goes dead, hazards come on and flash every time. Reattempted programming, same thing, but now PCM needs no update. After several screens of turn key on, it programmed the PCM and said failure to program TCM. Hazards come on and it says turn key to on position. as soon as programming starts, dash goes dead. After I attempt to start programming, Key off, then key on. ![]() Using Ford IDS, when I get to TCM programming stage, PMI, it informs me of multiple memory locations, then asks me if it has certain part numbers (early or late) It does not. #Ford diagnostic program softwareThis VCI Software package WILL NEED to be downloaded in order to use your VCM II or VCMM, regardless of whether this is the first time you have downloaded IDS/FDRS. There is now a new package separate from IDS and FDRS, called VCI Software. Shop called me in to program a TCM on this 2012 Fiesta. a VCM II/VCMM with any of the Ford diagnostic software (IDS, FDRS & VMS). Sorry if this post is lacking the total details but I'm hoping someone can tell me I'm over thinking this one. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |